CowDream glue Standard 200 ml

  • Two components
  • Polyurethane adhensive
  • Sets within 30 sec.
  • Fully strain after 2-4 min.

Recommended used together with CowDream mixingtip (1003846KVK)

 

1003860KVK

SKU: 1003860KVK Category:

Product benefits

Easy and quick application

The adhesive is very easy to apply due to the use of mixing tips.

Animal welfare

Thanks to the possibility of sticking the block on, we relieve the sick hoof by supporting the healing process.

Fast-setting

The glue sets within 30 seconds.

Perfect for all types of blocks

We will glue both wooden and rubber blocks with CowDream glue.

Product characteristic

Easy and quick application
CowDream glue is a two-component polyurethane glue equipped with a replaceable mixing tip system, thanks to which the glue application is quick and very easy. One cartridge is enough for 8 to 10 glue application depending on the hoof size.

Fast-setting
The glue sets within 30 seconds, and after about 2-4 minutes the animal can already walk on the leg to which the block was glued.

In order for the adhesive to stick properly, we must first clean and dry the hoof. The storage temperature should not be below 5 °C because then the adhesive may lose its properties. It is optimal to store the adhesive at a temperature of about 25 ° C. The adhesive can be used both in summer and winter.

Perfect for all types of blocks
CowDream glue is the perfect solution for both wooden blocks, rubber blocks and rubber boots. The use of two-component CowDream glue gives us confidence that the glued block will remain in place at all times.

In our offer you will also find a glue dispensing gun and mixing tips for CowDream glue.

Further information

How to apply the adhesive correctly
The adhesive should be placed in the application gun. Then remove the glue plug and place a mixing tip in its place, which will allow us to mix the glue components. Now align the cartridge with the adhesive by setting it straight up, and then squeeze the gun handle to apply to remove air.

Then remove the small amount of glue that has appeared, so that the two components mix best together. Now you can apply glue to the prepared block, which will then be placed quickly on the cleaned and dried hoof. We recommend using a hot air gun to dry the hoof.

After about 30 seconds, the glue will have set, and after 2-4 minutes the claw will be able to bear the weight of the animal again. The mixing tip should remain on the cartridge until the adhesive is needed again. Only then change the mixing tip to a new one.

It is very important for good adhesion of the glue that the hoofs are properly prepared for this treatment. It must be cleaned and dried. The claw can be cut so that it has a rough surface, thanks to which the grip will be better. Pressing the block smeared with glue can not do it with too much force because then too much glue can flow out and between the hoof and the block its layer will be too thin.

Animal welfare
Currently, care and concern for animal health requires a professional approach to treating hooves. Contemporary hoof care is currently undergoing many changes in support and improvement of professional claw treatment. To make the right treatment decision, we need to familiarize ourselves with the characteristics of the ailments that farm animals face.

Safety
click for more info

Often bought together

Customer reviews

betoffice
izmir şehirler arası nakliyat bodrum evden eve nakliyat İstanbul izmir evden eve nakliyat ofis taşıma İstanbul Antalya evden eve nakliyat Marmaris şehirler arası nakliyat şehirler arası nakliyat parça eşya taşıma
https://www.fapjunk.com https://fapmeister.com
X