Hoof-Tite COLD is the next generation of hoof glue. The COLD edition includes a new formula that is stronger, faster and better. The adhesive turns blue and becomes fast hard even at low ambient temperatures.

Easy and quick application
The Hoof-Tite adhesive is a two-component adhesive developed by hoof trimmers and is equipped with a replaceable Easy On / Easy Off mixing tip system, which makes the application of the adhesive quick and easy. One cartridge is enough for 8 to 10 glue application depending on the hoof size

Fast-setting
The glue sets within 30 seconds, and after about 2-3 minutes the animal can already stand on the leg to which the block was glued.

In order for the adhesive to stick properly, we must first clean and dry the hoof. The storage temperature should not be below 5 °C because then the adhesive may lose its properties. It is optimal to store the adhesive at a temperature of about 25 ° C. The adhesive can be used both in summer and winter.

Perfect for all types of blocks
Hoof-Tite Cold glue is the perfect solution for both wooden blocks and rubber blocks. The use of two-component Hoof-Tite glue gives us confidence that the glued block will remain in place at all times.

In our offer you will also find a dispensing gun and mixing tips for Hoof-Tite Cold glue.

How to apply the adhesive correctly
The adhesive should be placed in the application gun. Then remove the glue plug and place a mixing tip in its place, which will allow us to mix the glue components. Now align the cartridge with the adhesive by setting it straight up, and then squeeze the gun handle to apply to remove air.

Then remove the small amount of glue that has appeared, so that the two components mix best together. Now you can apply glue to the prepared block, which will then be placed quickly on the cleaned and dried hoof. We recommend using a hot air gun to dry the hoof.

After about 30 seconds, the glue will have set, and after 2-3 minutes the claw will be able to bear the weight of the animal again. The mixing tip should remain on the cartridge until the adhesive is needed again. Only then change the mixing tip to a new one.

It is very important for good adhesion of the glue that the hooves are properly prepared for this treatment. It must be cleaned and dried. The claw can be cut so that it has a rough surface, thanks to which the grip will be better. Pressing the block smeared with glue can not do it with too much force because then too much glue can flow out and between the hoof and the block its layer will be too thin.

Animal welfare
Currently, care and concern for animal health requires a professional approach to treating hoofs. Contemporary hoof care is currently undergoing many changes in support and improvement of professional hoof treatment. To make the right treatment decision, we need to familiarize ourselves with the characteristics of the hoof problems that farm animals face.

Safety
click for more info